Rapid Grip™ Contact Adhesive Liquid is a low viscosity, general purpose adhesive.
Not recommended for: plasticised PVC, permanent water immersion eg.swimming pools. Do not apply at temperatures below 5°C.
All surfaces must be clean, sound and free of dust, standing water, oil or contamination.
CONTACT BONDING: Apply a thin uniform coating of H.B. Fuller Rapid Grip™ Liquid contact adhesive over the back of the laminate and then over the surface to be bonded. Special attention should be given to ensure that the edges are completely coated.
When both surfaces are touch dry (10 to 30 minutes) carefully position the laminate over the base surface. Use a sheet of strong glazed paper or wooden dowels to separate, to ensure that the adhesive coated surfaces do not touch. Remove separators one by one and firmly press the coated surfaces together.
Working from the centre outward hammer with a block covered in felt or run the laminate through a set of pinch rollers. Pay particular attention to the edges.
WET BONDING: A wet bond may be made when small surface areas are to be joined and at least one substrate is porous. Apply a uniform coat of H.B. Fuller Rapid Grip™ Liquid contact adhesive to one surface, and then join the surfaces. Clamp or hold surfaces together until dry.
Water Based Construction Adhesive
Heavy Duty Construction Adhesive (NZ only)
Solvent based cleaner