Fulaoam Cleaner is a solvent based cleaner for cleaning uncured polyurethane from applicator guns or other surfaces. The cleaner can be used to clean the gun when either Max Bond™ Pro or Fula Foam™ Pro have been used.
Fulafoam Cleaner cannot dissolve cured foam.
Shake can vigorously, at least 20 times, to mix contents.
CLEANING OF GENERAL SURFACES: Attach the red nozzle to the can and gently depress to nozzle to emit the cleaner.
CLEANING OF APPLICATOR GUN: Wear impervious gloves, protective eye wear and suitable work clothes during use. Use with adequate ventilation.
Load Fulafoam Cleaner onto the applicator gun by screwing the can into the top of the gun. Do not over-tighten. To clean the gun, open the screw valve at the rear of the gun. Gently press gun trigger to release left over foam. The rate of extrusion can be varied by turning the screw thread at the rear of the gun. Let Fulafoam Cleaner™ soak in applicator gun for 1-2 minutes. Pull gun trigger to release cleaner. Repeat steps until clear solvent is released from the gun.
When the gun has been cleaned, close the valve at the rear of the gun and remove Fulafoam Cleaner™ can. Re-open the valve and press the gun trigger to depressurize the gun. Attach a new can of foam and store gun.
Water Based Construction Adhesive
Heavy Duty Construction Adhesive (NZ only)